Reference Information
32
About Copyright Protection:
The AV receiver supports Revision 1.4 of the HDCP
(High-bandwidth Digital Content Protection) (
2), a
copy-protection system for digital video signals. Other
components connected to the AV receiver via HDMI must
also support HDCP.
*1 DVI (Digital Visual Interface): The digital display interface standard set
by the DDWG (
3) in 1999.
*2 HDCP (High-bandwidth Digital Content Protection): The video
encryption technology developed by Intel for HDMI/DVI. It is designed
to protect video content and requires a HDCP-compatible HDMI/DVI
receiver to display the encrypted video.
*3 DDWG (Digital Display Working Group): Lead by Intel, Compaq,
Fujitsu, Hewlett Packard, IBM, NEC, and Silicon Image, this open
industry group’s objective is to address the industry’s requirements for
a digital connectivity specification for high-performance PC and digital
displays.
Note:
The HDMI video stream (i.e., video signal) is compatible with
DVI (Digital Visual Interface), so TVs and displays with a DVI
input can be connected by using an HDMI-to-DVI adapter cable.
(Note that DVI connections only carry video, so you will need
to make a separate connection for audio.) However, reliable
operation with such an adapter is not guaranteed. In addition,
video signals from a PC are not supported.
The HDMI audio signal (sampling rate, bit length, etc.) may be
restricted by the connected source component. If the picture
is poor or there is no sound from a component connected via
HDMI, check its setup. Refer to the connected component’s
instruction manual for details.
USB Storage Device Requirements
USB mass storage device class (but not always
guaranteed).
FAT16 or FAT32 file system format.
If the USB storage device has been partitioned, each
section will be treated as an independent device.
Up to 20,000 folders can be displayed, and folders may
be nested up to 16 levels deep.
USB hubs and USB storage devices with hub functions
are not supported. Do not connect these devices to the
unit.
Note:
If the media you connect is not supported, the message "No
Storage" will be displayed.
Sound files that are protected by copyright can not be played.
When the USB audio player and this unit are connected, the
audio player screen and the screen of the unit may be different.
In addition, control functions of the audio player (classifying and
sorting music files and adding information, etc.) are not available
on this unit.
Do not connect a PC to the USB port of the unit. Inputting sound
to the USB port of the unit from a PC is not possible.
Media inserted to the USB card reader may not be available in
this function.
Some USB storage devices and its contents may require some
time to be read.
Depending on the USB storage device, proper reading of the
contents and proper supply of the power supply may not be
possible.
Onkyo accepts no responsibility whatsoever for the loss or
damage to data stored on a USB storage device when that
device is used with this unit. We recommend that you back up
your important music files beforehand.
Performance of the hard disk that receive power from the USB
port of the unit is not guaranteed.
If you connect a USB hard disk drive to the USB port of the unit,
we recommend that you use its AC adapter to power it.
When an audio player that are operated with batteries is used,
make sure that the batteries have enough remaining power.
USB devices with security functions can not be played.
Supported Audio Formats for USB Playback
For server playback and playback from a USB storage
device, this unit supports the following music file formats.
Variable bit-rate (VBR) files are supported. However,
playback times may not be displayed correctly.
This unit supports the gapless playback of the USB
storage device in the following conditions.
When WAV, FLAC and Apple Lossless files are
continuously played back with the same format,
sampling frequency, channels and quantization bit rate.
■
MP3 (.mp3 or .MP3)
Supported formats: MPEG-1/MPEG-2 Audio Layer 3
Supported sampling rates: 8 kHz, 11.025 kHz, 12 kHz,
16 kHz, 22.05 kHz, 24 kHz, 32 kHz, 44.1 kHz, 48kHz
Supported bitrates: Between 8 kbps and 320 kbps and
VBR.
■
WAV (.wav or .WAV)
WAV files contain uncompressed PCM digital audio.
Supported sampling rates: 8 kHz, 11.025 kHz, 16 kHz,
22.05 kHz, 32 kHz, 44.1 kHz, 48 kHz, 64 kHz, 88.2 kHz,
96 kHz
Quantization bit: 8 bit, 16 bit, 24 bit
■
FLAC (.flac or .FLAC)
FLAC is a file format for lossless audio data
compression.
Supported sampling rates: 8 kHz, 11.025 kHz, 12 kHz,
16 kHz, 22.05 kHz, 24 kHz, 32 kHz, 44.1 kHz, 48 kHz,
64 kHz, 88.2 kHz, 96 kHz, 176.4 kHz and 192 kHz
Quantization bit: 8 bit, 16 bit, 24 bit
■
Ogg Vorbis (.ogg or .OGG)
Supported sampling rates: 8 kHz, 11.025 kHz, 16 kHz,
22.05 kHz, 32 kHz, 44.1 kHz, 48 kHz
Supported bitrates: Between 32 kbps and 500 kbps and
VBR.
Incompatible files can not be played.
■
Apple Lossless (.m4a/.mp4/.M4A/.MP4)
Supported sampling rates: 8 kHz, 11.025 kHz, 12 kHz,
16 kHz, 22.05 kHz, 24 kHz, 32 kHz, 44.1 kHz, 48 kHz,
64 kHz, 88.2 kHz, 96 kHz
Quantization bit: 16 bit, 24 bit
■
DSD (.dsf or .DSF)
Supported sampling rates: 2.8224 MHz
