A SERVICE OF

logo

Removal and Replacement
TDS 310, TDS 320 & TDS 350 Service Manual
6Ć11
Fuse
Figure 6Ć3:ăLine Fuse Removal
7. Reinstallation: Do in reverse steps 6 through 3 to reinstall the line fuse
and then the line cord.
1. Have handy a pair of angledĆtip tweezers (Item 7).
2. Set the oscilloscope so its bottom is down on the work surface and its
front is facing you.
3. Refer to Figure 6Ć4. Grasp any knob you wish to remove and pull it
straight out from the front panel slightly to create some clearance
between the base of the knob and the front panel.
4. Insert the tweezers between the knob and front panel and use them to
remove the knob and its shaft.
5. Pull the shaft out of the knob to remove.
Front Panel Knobs
and Shafts