A SERVICE OF

logo

Troubleshooting
TDS 310, TDS 320 & TDS 350 Service Manual
6Ć39
Yes
No
No
Use this procedure to
determine if a problem is
caused by the Front Panel
module or the Main board.
Press the
ON/STBY button
to the on position.
Is
the ON/STBY
button working
correctly?
No
Yes
Is
the bezel
flex circuit securely
installed in J40 and
is the flex circuit
securely mounted
on chassis?
Do all the
Front Panel
LEDs turn on
and then off a
short time
later?
Replace the Front
Panel module.
Securely install
and or replace the
bezel flex circuit.
No
Do
the Front Panel
LEDs turn on
at all?
Yes
No
Yes
Is
the Front
Panel cable
securely installed at
J30 and J603 and is
the cable
ok?
Securely install
and/or replace the
Front Panel cable.
Replace the
Main board.
No
Yes
Is
there 5 V on
pins 2 and 4 of
J30?
Securely install
and or replace the
bezel flex circuit.
Yes
No
Yes
Do the
Front Panel
controls operate
correctly?
Front Panel
Module is ok.
Replace the
Front Panel
Module.
Figure 6Ć22:ăFront Panel/Processor Troubleshooting Procedure