Filter
Top Products
- 7 -
CHARGING WITH LOGIC SERIES CHARGERS
Charge this battery fully before using. Allow the battery to reach a steady
green (Lifesaver) mode before using. Charging is automatic on all Logic
Series chargers. The flashing red and green lights indicate the charger
and battery are establishing communications. The following are the
standard indications on any Logic Series Lifesaver Charger (Please refer
to the Charger manual for complete Charger instructions):
• Alternating red and green: Evaluating battery and/or
rejuvenating low voltage battery.
• Steady red: Battery waiting to charge (may either be in line to
charge or holding for temperature stabilization).
• Flashing red: Charging.
• Flashing green: Balancing mode or Ready/Verifying. Battery is
typically more the 80% charged.
• Steady green: Lifesaver mode. Batteries will remain 100%
ready for use indefinitely.
The battery should remain on the charger until just prior to being
used. The patented Lifesaver maintenance routine keeps the battery
100% charged and balanced by eliminating the typical self-discharge that
can cripple a battery that is stored for any length of time on the shelf. Do
not remove the DIGITAL batteries from the charger more than 8 hours
prior to actual use. For best results, this battery should be returned to the
Logic Series charger within 48 hours of being used. Please read the
individual charger Owner’s Manual to become acquainted with the many
unique features of the Logic Series chargers.