Filter
Top Products
- 11 -
RealTime Display Indications
• When the battery is being charged no remaining runtime is displayed.
• Remaining run time is calculated using the present available battery
capacity and a constantly updated accurate measurement of the
present load on the battery.
• If no load is detected, or if the battery is removed from the charger
before any discharge load is applied, the default assumed power for
remaining run time calculations is 20 Watts.
• When the battery determines that a load is attached, remaining run
time will be calculated based on that load and the time remaining will
be updated.
• The battery will “learn” this new load and retain that load information
in non-volatile memory. If the battery is removed from the camera it
will retain this information for 30 minutes or until it is returned to the
charger or sees a new load. After 30 minutes the battery will return to
the default load of 20 watts.
• OVERCURRENT INDICATION
If the battery is subjected to a load that exceeds specifications all
status icons on the LCD will flash at a once per second rate. When
the over-load condition is removed, the display will return to normal.
• When the battery is completely discharged the LCD will flash the 15
minute icon until the battery is returned to a charger.