Filter
Top Products
-10-
BB4<1;H
)>>;B#44343>ABB4<1;H=3;86=<4=C
Should be no Gap or Overlap
when Square is Flipped Over
in Dotted Position
Draw Light
Line on Board
Along this Edge
Hex “L” Wrench
(supplied) 1.5mm
Straight Edge of Board 3/4"
Thick This Edge Must be
Perfectly Straight
Multi Purpose Tool (supplied
with model 5412 only)
Combination Square Must be True
Combination Square
10mm/17mm Combination
Open End Wrench
Multi Purpose “L” Wrench 6.5mm
(supplied with model 5312 only)
*=?02:8=6=3742:8=6>=C4=CB
Before moving the saw: Lock the
miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly com-
pletely toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
#4E4A20AAHC74C>>;1HC74B;834A08;BC78B<0H
20DB41;03430<064
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connec-
tions could cause a fire.
Models 5312 & 5412 Miter Saws are shipped complete
in one box.
1. Separate all parts from packing materials and
check each one with the “Table of Loose Parts” to
make sure all items are accounted for before
discarding any packing material.
2. Table of Loose Parts:
Quick- Action Clamp (Model 5412 only) - Used to
clamp workpieces.
Workpiece Clamp (Model 5312 only) - Used to
clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Multi Purpose Tool (Model 5412 only) - Should
be stored on the right rear base.
Rear Cord Wrap, washer and Screw - Used for
wrapping the cord
Miter Lock Knob - Used to lock the table at de
sired miter angle.
If any parts are missing, do not
plug in power cord or turn the
switch on until the missing parts are obtained and
are installed correctly.
CC0278=6"8C4A!>2: =>1
Locate the miter gauge lock knob from among the
loose parts, and thread shaft on lock knob into hole
provided.
CC0278=6'40A>A3,A0?
Locate the rear cord wrap from among the loose
parts, position rear cord wrap as shown and secure
with washer and phillips screw provided.
Disconnect plug from power source before performing any assembly, adjustment or repair
to avoid possible injury.
!
WARNING
!
WARNING
!
WARNING
UNLOCK
LOCK
'40A>A3,A0?
%78;;8?B(2A4F
,0B74A
"8C4A0D64
!>2: =>1
2610009642 10/09 E:2610009642 10/09 E 10/20/09 3:17 PM Page 10