Filter
Top Products
BBD<?C8>=B Molding is milled consistently.
• Corner is 90 degrees.
• For other corner angles, divide actual measure-
ment by 2.
-30-
The preferred method for cutting crown molding with
this saw is with the molding laying flat on the table.
• The advantage to cutting moldings angled against
fence is that no bevel setting is required. Only the
miter angle is adjusted.
• The maximum crown molding width that can be cut
and angled to table and fence is 6".
• When cutting crown molding in this fashion it is
recommended to purchase and use the optional
MS 1221 Horizontal Clamp and Crown Molding
Stop Accessory.
>;;>FC74B48=BCAD2C8>=B5>A2DCC8=6
2A>F=<>;38=60=6;43C>C01;40=354=24
1. Position the molding so the bottom (decorative
part, which is installed against the wall) is against
the fence.
2. For 90º corner, set the miter angle using Chart
below. Tighten the miter lock knob (Figure 36).
3. Support crown molding against the fence (see
“Body and Hand Position” on page 19.)
4. Follow the procedures for chop or slide cut (see
page 23).
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
#$) !,.( ) )() *) *(#
('%)$$#'"$'')#!(
(0F$?4A0C8>=B
A>F=">;38=6=6;43C>)01;40=34=24
L"8C4A
A>F=">;38=6=6;43
608=BC4=24
86DA4A>F=">;38=6=6;43C>
)01;40=34=24
>A0=HA>F=">;38=6
"8C4A 4E4;
)01;4)8;C
(4CC8=6(4CC8=6
=B834>A=4A
Left end (A) (45) Right 0 Left
Use the right end
of the cut
Right end (B) (45) Left 0 Right
Use the left end
of the cut
$DCB834>A=4A
Left end (C) (45) Left 0 Right
Use the right end
of the cut
Right end (D) (45) Right 0 Left
Use the left end
of the cut
"8C4A0=34E4;(4CC8=6B5>A(C0=30A3A>F=">;38=6DCB
,74=,>A:?8424=6;43608=BC4=24
2610009642 10/09 E:2610009642 10/09 E 10/20/09 3:19 PM Page 30