Filter
Top Products
Operating Instructions
Power Pack
IN974302AV 6/13© 2013 Campbell Hausfeld/Scott Fetzer For parts, product & service information
visit www.campbellhausfeld.com
GR3000
RETAIN THIS INFORMATION FOR FUTURE REFERENCE
Serial Number:
Model Number:
Date of Purchase:
Table of Contents
Description . . . . . . . . . . . . . . . . . . . . . . . . . 1
Unpacking..........................1
Safety Guidelines ....................2
Safety Symbols ......................2
Important Safety Information .....2 - 5
Glossary of Terms....................6
Pre-operation ....................7 - 8
Generator Operation..............8 - 9
Welder Operation ..................10
Compressor Operation..............10
Maintenance...................11 - 12
Storage .........................12
Welding Guidelines .............13 - 16
Troubleshooting Chart ..........16 - 18
General.........................16
Generator.......................17
Welder..........................17
Welds ..........................18
Wiring Diagram ....................19
Warranty ..........................20
Breathable Air Warning
This product is neither designed, nor approved by the National Institute for
Occupational Safety and Health (NIOSH), for use as a supplied air system.
Description
Power Pack is a mobile power source that can provide solutions for jobs offsite and in
remote powerless locations. It can be used as a generator, welder, or air compressor.
Powered by an air-cooled four cycle engine, this machine is designed to run at
maximum RPM. The Power Pack offers protection features such as; low-oil level shutoff
which provides protection for the engine; and a thermostatically protected alternator.
The welding system is designed to weld in the Stick process (SMAW). The 140 amp AC
stick welder can weld up to 5/16 inch steel.
The air compressor provides compressed air to power pneumatic tools and operate
spray guns. The pump is oil lubricated; therefore a small amount of oil carryover is
present in the compressed air stream. NOTE: Applications requiring air free of oil or
water should have the appropriate coalescing filter installed.
Unpacking
After unpacking the unit, inspect carefully for any damage that may have occurred
during transit. Make sure to tighten fittings, bolts, etc., before putting unit into service.
Report any missing items by calling 1-800-746-5641.
Do not operate unit if damaged during shipping, handling or use.
Damage could result in bursting and cause injury or property damage.
RegisteR youR pRoduct online now!
http://www.campbellhausfeld.com