Filter
Top Products
12
Operating Instructions and Parts Manual
HVLP Paint Sprayers
www.chpower.com
HV2100, HV2105
No paint comes out when
trigger is pulled
Excessive overspray
Coating on surface of
work piece is not flat and
level after drying (orange
peel effect)
When spray gun is
connected to turbine and
turbine is on, air
continually flows through
air cap even if trigger is
not pulled
1. Cup not pressurizing due to
loose fittings
2. Cup not pressurizing due to
loose cup connection
3. Cup top gasket damaged
4. Blockage in “C” shaped tube
underneath cup top lid
1. Too much distance from
spray gun to work piece
2. Too much spray material
coming out
3. Too much air power behind
pressure stream
4. Tip/needle assembly too large
Coating not strained/thinned
properly
N/A. This is normal and expected.
“Bleeder” type guns are set up
this way to help increase the life
of the turbine motor.
1. Check air feed tube/one way air valve and air feed
connector.
2. Make sure cup is screwed on or clamped on tightly.
3. Check for damage and replace if necessary.
4. Look under cup top lid. Locate “C” shaped tube. Remove
blockage from it.
1. Move spray gun closer to work piece.
2. Decrease the amount of spray material flowing through
spray gun.
3. Reduce air power (use optional air control/texturing
device).
4. Use a smaller tip/needle assembly instead of the current
one you are using.
Thin coating more.
Symptom Possible Cause(s) Corrective Action
Troubleshooting Chart