Filter
Top Products
SKU 47606 For technical questions, please call 1-800-444-3353. Page 6
REV 07c; 07j
Main Handle (89)
Handle
(505)
Knob (701)
Switch (86)
Bit
Drill Stop (504)
Bit Sleeve
FIGURE 3
Brush Cap (70)
Bit Sleeve
FIGURE 2
Note: Break Point (Bull) Bits and cold
chisels are to be used when the Selector
Switch is in the hammering position only.
Using these bits/chisels with the Selector
Switch in the hammer/drill position will
result in unexpected tool performance.
Inserting and removing bits.
1. Make sure the Rotary Hammer is not plugged in.
2. To insert a bit, pull back and retract the Bit Sleeve (see FIGURE 2) and insert the bit. Slide
the two notches on the bit into the notched receptacle and then release the Bit Sleeve. Put
on gloves and then tug on the bit forcefully, making sure it is in the Bit Sleeve rmly.
3. When removing a bit, make sure the bit has had a chance to cool. Wear gloves and grip
the bit with one hand, and pull back on the Bit Sleeve, retracting it away from the bit. Pull
out the bit.
Note For safe, optimal performance, keeps bits and chisels properly sharpened. Never use a
dull, cracked, or chipped bit.