Filter
Top Products
SKU 92496 PAGE 14
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Welding Kit is cool to the touch and
disconnected from its oxygen and acetylene cylinders before performing
any inspection, maintenance, or cleaning procedures.
2. BEFORE EACH USE, inspect the general condition of the Welding Kit. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged Welding Hoses (D1A, or D1B), and any other condition that may affect
its safe operation. If a problem occurs, have the problem corrected before further
use. Do not use damaged equipment.
3. PERIODICALLY, use the Tip Cleaner (D7) to clean out dirt and debris from the
Nozzle (parts D4). Make sure to use the correct size Tip Cleaner for each individual
Nozzle. (See Assy. Diagram E.)
4. TO CLEAN, use a clean cloth. If necessary, a mild detergent may be used.
Do not immerse any part of the Welding Kit in liquid.
Do not use solvents or other flammable agents to clean the Welding Kit.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND
ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE
MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY
OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS
TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF
THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF
HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.