Filter
Top Products
RECOMMENDED ACCESSORIES
[AWARNING[
• Use only accessories recommended for this
miter saw. Follow instructions that accompany
accessories. Use of improper accessories may
cause hazards.
• The use of any cutting tool except 10 inch saw
blades which meet the requirements under
recommended accessories is prohibited. Do
not use accessories such as shaper cutters or
dado sets. Ferrous metal cutting and the use of
abrasive wheels is prohibited.
= Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious injury.
ACCESSORIES
Visit your Sears Hardware Department or see the
Sears Power and Hand Tool Catalog to purchase
recommended accessories for this power tool.
[_IL WARNING I
To avoid the risk of personal injury, do not modify this
power tool or use accessories not recommended by
Sears.
[_IL WARNING I
Read warnings and conditions on your CARBIDE TIPPED
SAW BLADE. Do not operate the saw without the proper
saw blade guard in place. Carbide isa very hard but
brittle material Care should be taken while mounting,
using and storing carbide tipped blades to prevent
accidental damage. Slight shocks, such as striking the
tip while handling, can seriously damage the blade.
Foreign objects in the workpiece, such as wire or nails,
can also cause tips to crack or break off. Before using,
always visually examine the blade and tips for bent
blade, cracks, breakage, missing or loose tips, or other
damage. Do not use if damage is suspected. Failure
to heed safety instructions and warnings can result in
serious bodily injury.
Supplied
Blade Wrench
Not supplied
...............................
Adjustable Wrench
Hex Key
Combination Square
Phillips Screwdriver
Slotted Screwdriver
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over
(see dotted figure).
Straight edge or
a 3,/4 in. board,
this edge must be
perfectly straight.
Draw light line on board
along this edge.
r_
t
f
I
t
Gap from untrue square
when flipped over.
6