Filter
Top Products
13
Fig. 24
Fig. 25
Fig. 26
Fig. 28Fig. 27
10. Loosen track arm clamp handle (Y) Fig. 24. NOTE:
Track clamp handle (Y) has left handed threads. Press
down on indexing release handle (Z) and pivot track arm
(X) to the left until motor shaft (B) Fig. 25, is near front left
adjustment screw (P) of table board (A) as shown. Then
tighten track arm clamp handle (Y) Fig. 24.
11. Place an arbor wrench (D) Fig. 25, between table
board (A) and motor shaft (B). Lower track arm (X)
Fig. 24, by turning elevating handle (C) counterclockwise
until motor shaft (B) Fig. 25, barely touches arbor
wrench.
12. Check the height of the table board above the other
three table board adjustment screws (E) Fig. 26, by re-
positioning track arm (X), and cutting-head assembly (V)
until the highest point of the table is determined. NOTE:
MAKE CERTAIN CUTTING-HEAD CLAMP KNOB (W)
FIG. 27 AND TRACK ARM CLAMP HANDLE (Y) ARE
TIGHTENED WHEN MOTOR SHAFT IS LOCATED
ABOVE EACH OF THE ADJUSTMENT SCREWS. DO
NOT CHANGE HEIGHT OF TRACK ARM (X) FIG. 26,
UNTIL HIGHEST SCREW IS DETERMINED, AND ALL
FOUR CORNERS OF THE TABLE BOARD HAVE BEEN
ADJUSTED.
13. Position the motor shaft back over the three lower
corners of the table board and adjust the table
adjustment screws (E) Fig. 26, until the arbor wrench fits
accordingly between the arbor shaft and table board in
each location.
14. Once the table board (A) Fig. 28, is properly ad-
justed, tighten three nuts (G) on each side of saw base
(H). Then return track arm (X) and motor (V) to the
90 degree position as shown, and tighten bevel clamp
lever (S) and track arm clamp handle (Y) Fig. 27.
W
C
X
Y
Z
D
A
P
B
X
V
E
Y
W
A
S
V
H
G
G
X