Filter
Top Products
14
Fig. 29
Fig. 30
Fig. 31
Fig. 32
ASSEMBLING
TABLE BOARD CLAMPS
AND TABLE BOARDS
1. Locate table board clamps (A) Fig. 29, and insert
one clamp into each of the slotted holes (B) located at
the rear of each table support bracket (C) as shown in
Fig. 30.
2. Adjust clamps (A) Fig. 30, so that the clamps are
open entirely as shown, by turning knobs (D).
3. Place 1-1/4″ wide board (E) Fig. 31, against front
table board (G), 1-3/4″ wide board (H) in the upright
position against 1-1/4″ board, and 5-3/4″ wide board (J)
against 1-3/4″ wide board as shown. Then tighten knobs
(D), until the table boards are securely clamped in
position.
ADJUSTING
AND CHECKING
SAW BLADE TRAVEL
SQUARE TO FENCE
1. DISCONNECT TOOL FROM POWER SOURCE.
2. Position rear and middle table boards with 1-3/4″
wide fence board (H) Fig. 32, in the rear position as
shown.
3. Raise track arm (A) Fig. 32, by turning elevating
handle (B) until the blade (C) can be assembled on the
motor shaft. Then tighten arbor nut (D) using the
wrenches supplied.
4. Place a framing square (E) Fig. 32, against fence (H)
and blade (C) as shown, and lower track arm (A) until the
blade just clears the table surface.
A
B
C
D
A
A
D
G
H
E
J
D
D
H
E
C
D
A
B