Filter
Top Products
16
Fig. 40
Fig. 41
Fig. 42
Fig. 43
REPLACING
SANDING BELT
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Loosen screw (A) Fig. 40, and remove backstop (B).
3. Slide tension lever (C) Fig. 41, to the right to release
tension on sanding belt and remove sanding belt (D) from
both sanding drums, as shown.
4. Slide new sanding belt over both sanding drums
making sure the belt will run in the direction of the arrow
located on the inside of the belt.
5. Re-apply belt tension by sliding tension lever (C)
Fig. 41, to the left.
6. Replace backstop which was removed in STEP 2.
7. Connect electrical power to the sander and check to
see if the belt is tracking properly. If not, refer to the
section “TRACKING THE SANDING BELT”.
REPLACING
SANDING DISC
When it becomes necessary to replace the sanding disc,
proceed as follows:
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Loosen screw (A) Fig. 42, and remove table
assembly (B).
3. Remove three screws (C) Fig. 43, and lower cover
(D).
A
B
C
D
A
B
D
C