Filter
Top Products
10
TIGHTEN ALL HARDWARE IN
SEQUENCE (FIG. 18, 19)
Using a 12 mm wrench (not included), tighten hardware in
this order:
1. Tighten six bolts on motor/blower housing.
2. Tighten all six bolts that attach the side and front
panels to the base.
3. Tighten four bolts that attach the cross panel to the
side panels.
FIG. 18
FIG. 19
INSTALLINTAKEADAPTER(FIG.20,21)
with the four holes — one shown at (W) — underneath
the motor/blower housing. Attach the intake adapter with
four #8 self-tapping screws at four holes.
FIG. 20
FIG. 21
V
W