Delta 50-786 Dust Collector User Manual


  Open as PDF
of 52
 
3
• Donotleavedustcollectorwhenpluggedin.Unplug
from outlet when not in use and before servicing.
•
To reduce the risk of electric shock, do
not use outdoors or on wet surfaces.
• Donotallowtobeusedasatoy.Close attention is
necessary when used by or near children.
• Use only as described in this manual. Use only
manufacturer’s recommended attachments.
• Donotusewithdamagedcordorplug.If dust collector
is not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return it to a service
center.
• Donotpullorcarrybycord,usecordasahandle,
close a door on cord, or pull cord around sharp edges
or corners. Do not run dust collector over cord. Keep
cord away from heated surfaces.
• Donotunplugbypullingoncord.To unplug, grasp the
plug, not the cord.
• Donothandleplugordustcollectorwithwethands.
• Donotputanyobjectintoopenings.Do not use with
any opening blocked; keep free of dust, lint, hair, and
anything that may reduce air flow.
• Keephair,looseclothing,fingers,andallpartsofbody
away from openings and moving parts.
• Turnoffallcontrolsbeforeunplugging.
• Do not operate this unit until it is completely
assembled and installed according to the instructions.
A unit incorrectly assembled can cause injury.
• Obtainadvicefromyoursupervisor,instructor,or
another qualified person if you are not thoroughly
familiar with the operation of this unit. Knowledge is
safety
• Follow all wiring codes and recommended
electrical connections to prevent electrical shock or
electrocution.
• Do not pull this unit by thepower cord. Do not
allow the power cord to come in contact with sharp
instruments or edges, hot surfaces, or oil or grease.
Do not place any weight on top of the power cord. A
damaged power cord can cause electrical shock or
electrocution.
• Maintaintheunitintopcondition.Keep fan area clean
for best and safest performance. Clogged filters can
increase the potential for fire or explosion. Follow all
instructions for changing and cleaning filters. Also, ensure
that the intake and exhaust areas are clear prior to starting
the unit. Clogged intakes or exhausts can cause an
explosion and/or fire.
• Keeparms,hands,andfingersawayfromthefan.
Avoid all exposure to rotating parts to prevent injury.
• Donotoperatethisunitwithoutthedustcollection
bag in place and properly secured. Sawdust and other
debris can provide the potential for fire and/or explosion
and can also cause inhalation problems.
• Staticshocksarepossibleindryareasorwhenthe
relative humidity of the air is low. This is only temporary
and does not affect the use of the vacuum. To reduce the
frequency of static shocks, add moisture to the air with a
console or installed humidifier.
• To avoid spontaneous combustion, empty dust
collection bag after each use.
• Inspectthedustbagforcuts,rips,ortears.Replace
damaged bags or vacuum hoses. Sawdust and other
debris can provide the potential for fire and/or explosion
and can also cause inhalation problems.
• Do not attempt to remove or replace the dust
collection bag(s) while the unit is connected to the
power source. Exposed fan blades can cause severe
injuries.
• Store this unit in a location that eliminates the
potential for damage to the power cord. A damaged
power cord can cause shock or electrocution. Safely store
power cord on the unit to eliminate tripping hazards.
•
SEVERE LACERATION HAZARD.
Turn the unit "OFF," disconnect the unit from the power
source and wait 2-1/2 minutes to allow time for internal
rotating components to stop before installing or removing
accessories, before adjusting or changing set-ups,
clearing clogs or when making repairs. An accidental
start-up can cause serious injury.
• Turntheunit“OFF”, disconnect the unit from the
power source, and clean the work area before leaving
the area.
• Do not place open end of dust collection hose
anywhere near the eyes or ears while operating.
• Keep your workareacleanandwelllit.Cluttered
benches and dark areas invite accidents.
• Avoidbodycontactwithgroundedsurfacessuchas
pipes, radiators, ranges and refrigerators. There is an
increased risk of electric shock if your body is grounded.
• Somewoodcontains preservativeswhich canbe
toxic. Take extra care to prevent inhalation and skin
contact when working with these materials. Request and
follow any safety information available from your material
supplier.
Always use eye protection. All users and
bystanders must wear eye protection that conforms to ANSI
Z87.1.
Always wear proper personal hearing
protection that conforms to ANSI S12.6 (S3.19) during use.
Under some conditions and duration of use, noise from this
product may contribute to hearing loss.
ALWAYS use safety glasses. Everyday
eyeglasses are NOT safety glasses. Also use face or dust
mask if cutting operation is dusty. ALWAYS WEAR CERTIFIED
SAFETY EQUIPMENT:
• ANSIZ87.1eyeprotection(CAN/CSAZ94.3),
• ANSIS12.6(S3.19)hearingprotection,
• NIOSH/OSHA/MSHArespiratoryprotection.
This product contains chemicals, including
lead, known to the State of California to cause cancer, and
birth defects or other reproductive harm. Wash hands after
handling.
Some dust contains chemicals known to the
State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• compoundsinfertilizers
• compoundsininsecticides,herbicidesandpesticides
• arsenicandchromiumfromchemically-treatedlumber.
To reduce your exposure to these chemicals, wear approved
safety equipment such as dust masks that are specially
designed to filter out microscopic particles.
SAVE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
 previous next