Filter
Top Products
12
ATTACHING THE TOP FILTER
BAG (FIG. 27, 28)
(25.4 mm) hex head bolt (CC).
3. Insert bolt through the hole in the bracket, then
thread it into the hole in the dust collector. Tighten
securely with a 12 mm wrench.
4. Insert the rod into the pocket (EE) on the filter bag.
7. Work the open end of the filter bag into the top
groove of the dust collector drum until it is secure
and sealed. Bend and fold, as necessary, the
internal bag retainer ring to fit it into place.
ATTACHING THE DUST
COLLECTION BAG (FIG. 29, 30)
1. Bring the clear plastic dust collection bag up
through the middle of the cloth-covered bag
bag back down around the retainer ring.
into the bottom groove (II). Bend and fold the ring to
fit it into place.
3. Tug slightly on the bag to eliminate any slack and to
make sure that the bag is secure and will not detach
during collection.
BB
FIG. 27
CC
DD
FIG. 28
EE
FF
FIG. 29
FIG. 30
GG
GG
II
HH
FF