Filter
Top Products
8
ATTACH SIDE PANELS TO BASE (FIG. 5–8)
hex head bolt (L).
2. Line up holes (M) in side panel (N) with holes (O) in
base plate.
NOTE: Be sure side panel is oriented as shown in
hole (M) in the side panel and and hole (O) in base.
4. From underneath the base secure side panel to
5. Repeat for other hole in side panel and base.
two panels are shown correctly assembled in
Figure8.
NOTE:
order.
ATTACH CROSS PANELS TO
SIDE PANELS (FIG. 9, 10)
(19 mm) hex head bolt (L).
2. Line up four holes of cross panel (R) with four lower
holes in side panels (N).
3. Insert hex head bolt and washer assembly - (L) and
(K) (inset) - through holes in side panels (N) and then
through holes in cross panel (R).
5. Assembled cross panel is shown in Figure 11.
holes (SS).
NOTE:
order.
FIG. 5
FIG. 5
L
K
M
O
O
M
Q
FIG. 7
N
FIG. 6
FIG. 8
FIG. 9
L
K
R
N
N
Q
FIG. 10
FIG. 11
SS
SS