Delta 50-786 Dust Collector User Manual


  Open as PDF
of 52
 
9
ATTACH FRONT PANEL TO
BASE (FIG. 12–15)
 
hex head bolt (L).
2. Line up holes in front panel (N) with holes in base
plate (S), as shown in Figure 12.
NOTE: Be sure front panel is oriented as shown in
Figure13.
 
holes in front panel (N) and base plate (S).
4. From underneath the base secure front panel to

5. Repeat for other hole in front panel and base.
      
assembled in Figure 15.
NOTE:

order.
ATTACH MOTOR/BLOWER
TO STAND (FIG. 16, 17)
 
holes (T) in the housing with holes (U) in the stand.
 
hex head bolt (L).
3. Insert this washer/bolt assembly up through holes
(U) in stand and insert bolt into the threaded holes
(T) of the motor/blower housing. Hand tighten only.
4. Repeat for five remaining holes.
NOTE:

order.
FIG. 12
L
K
S
N
FIG. 13
FIG. 16
FIG. 17
T
U
L
K
FIG. 15
FIG. 14
Q
 previous next