Filter
Top Products
11
FIG. 22
ATTACHING HANDLE (FIG. 22–26)
from the top of the front panel.
2. Orient the clip (X) as shown in inset, with the
opening facing away from the dust collector.
3. Repeat for the other retaining clip on the other side
of the front panel.
4. Orient the handle as shown in Figure 23.
both sides of the front panel, as shown in Figure 23.
onto the ends of the handle that stick inside of the
front panel.
NOTE: These nuts (AA) are non-removeable. Make
sure the handle is properly oriented before installing
them.
X
X
Y
Z
FIG. 23
FIG. 24
AA
AA
FIG. 25 FIG. 26