Filter
Top Products
1212
OPERATING CONTROLS AND ADJUSTMENTS
Fig. 21
Fig. 22
Fig. 23
STARTING AND STOPPING SAW
The "ON/OFF" switch is located on the front side of the
band saw. To turn the saw "ON", push the button (A) Fig.
21 in to the "ON" position. To turn the saw "OFF", push
the button (B) Fig. 22 in to the "OFF" position.
LOCKING SWITCH IN THE “OFF”
POSITION
IMPORTANT: When the tool is not in use, the switch
should be locked in the "OFF" position to prevent
unauthorized use, using a padlock (C) Fig. 22 with a
3/16" diameter shackle.
In the event of a power outage, always lock the
switch in the "OFF" position until the main power is
restored.
OPENING AND CLOSING DOORS
When making adjustments such as changing the blade,
tracking the blade, blade guide adjustments, etc., the
doors (B) Fig. 23 can be opened as follows:
NEVER OPEN THE DOOR WHEN THE
MACHINE IS RUNNING.
1. Pull out the two locking latches (A) Fig. 23, and swing
doors (B) open.
2. Fig. 23A illustrates the doors (B) in open position.
3. To close and fasten doors (B) Fig. 23, press on the
doors directly over the latches (A) until the latches snap
into the locking position.
B
A
B
B
A
Fig. 23A
C