Filter
Top Products
1616
ADJUSTING THE TABLE
POSITIVE STOPS
Positive stops are provided for the table at the 90 and 45
degree angle to the blade. To check and adjust the
positive stops:
DISCONNECT MACHINE FROM POWER
SOURCE.
1. Tilt the table to the 90 degree position as shown in
Fig. 32 and tighten lock handle (A). Place a square (H) on
the table and against the blade and check to see if the
blade is 90 degrees to the table surface. If an
adjustment is necessary:
2. Tilt the table to expose the lock nut (E) Fig. 33.
Loosen lock nut (E) and return table to the 90° position.
With the lock handle (A) Fig. 32 loose, turn the adjusting
screw (F) Fig. 34, using the 3mm hex wrench provided
until the blade is 90 degrees to the table. Then tighten
lock handle (A) and lock nut (E) on the adjustment screw
(F).
3. Tilt the table to the 45 degree position as shown in
Fig. 34. Place a square (H) Fig. 34 on the table and
against the blade and check to see if the blade is 45
degrees to the table surface. If an adjustment is
necessary:
4. Loosen the lock nut (N) Fig. 33 on the adjustment
screw (J) located on the underside of the table. With the
lock handle (A) Fig. 34 loose, turn adjustment screw (J)
using 3mm hex wrench provided until the blade is 45
degrees to the table. Tighten lock handle (A) and lock
nut (N) on the adjustment screw (J).
Fig. 33
H
J
A
Fig. 32
H
F
E
Fig. 34
J
A
J
F
E
N
F