Filter
Top Products
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you
can tune them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the station is
to be preset, then press [CHANNEL] or [1 ~ 8] to select
the preset number.
b The memory block can also be selected by pressing [SHIFT].
4
Press [MEMO] again to complete the setting.
• To preset other stations, repeat steps 1 to 4.
• Stations can be preset automatically at GUI menu “Source Select”
– “Tuner” – “Auto Preset” (vpage 37).
NOTE
Preset stations are erased by overwriting them.
1
Either turn <SOURCE SELECT> or press [TUNER]
(AMP mode) to select “TUNER”.
1
(AMP mode) to select “TUNER”.
: ”Source Select” (vpage 36, 37)
2
To operate using the main remote control unit, set
the remote control unit to the TUNER (DEVICE1)
mode.
(vpage 59 “Remote Control Unit Operations”)
3
Press [BAND] to select “FM” or “AM”.
4
Tune in the desired broadcast station.
q To tune in automatically (Auto Tuning)
Press [MODE] to light the “AUTO” indicator on the display, then use
[df] to select the station you want to hear.
w To tune in manually (Manual Tuning)
Press [MODE] to turn off the display’s “AUTO” indicator, then use
[df] to select the station you want to hear.
Listening to FM/AM Broadcasts
• It is also possible to switch to “FM” or “AM” in step 1 by pressing
[TUNER].
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold [df] to change
frequencies continuously.
• The time for which the GUI menus are displayed can be set at GUI
menu “Manual Setup” – “Option Setup” – “GUI” – “Tuner” (vpage
34).
Basic Operation
<TUNING PRESET> <STATUS>
<SOURCE SELECT>
[BAND]
[df]
[A ~ G]
[CHANNEL]
[1 ~ 8]
[MODE]
[MEMO]
[TUNER]
,
[SHIFT]
[ TU]
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Getting Started Connections Setup Playback Remote Control Multi-Zone Information TroubleshootingGetting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
[df]
[SAT TU]
[ TU]
(DEVICE1 mode)
(AMP mode)
(AMP mode)
(DEVICE2
mode)