Filter
Top Products
• Use only accessories that are recommended by the manufac-
turer for your model. Accessories that may be suitable for one
tool, may create a risk of injury when used on another tool.
SERVICE
• Tool service must be performed only by qualified repair per-
sonnel. Service or maintenance performed by unqualified person-
nel may result in a risk of injury.
WARNING! DO NOT DISASSEMBLE LASER LEVEL. There are
no user serviceable parts inside. Disassembling the laser level will void
all warranties on the product. Do not modify the product in any way.
Additional Safety Rules
• The label on your tool may include the following symbols.
V ..............volts A ..........amperes
Hz ............hertz W ..........watts
min............minutes ........alternating current
..........direct current
n
o..........no load speed
............Class II Construction ........earthing terminal
…/min ......revolutions or ........safety alert symbol
................reciprocation per minute
Laser Safety
The DW071 Cordless Rotary Laser is listed as a CLASS IIIa LASER
PRODUCT and complies with the applicable requirements of title 21
of the Code of Federal Regulations set forth by: the Department of
Health, Education, and Welfare; the Food and Drug Administration;
the Center for Devices and Radiological Health.
DANGER: THIS PRODUCT EMITS LASER RADIATION - DO
NOT STARE INTO THE LASER BEAM
CAUTION: The use of optical instruments with this product will
increase eye hazard.
• Set the laser at a position above or below eye level.
• DO NOT disassemble the laser tool. There are no user serviceable
parts inside.
1
English
• When using the laser overhead, always use a ceiling wire hanger or
equivalent material in addition to the wall mount clamp to help
secure the laser level while mounting it to a wall. See “Wall Mount”
section for instructions.
• The use of controls or adjustments or procedures other than those
specified herein may result in Hazardous Radiation Exposure.
• DO NOT modify the laser in any way. Modifying the tool may result
in Hazardous Laser Radiation Exposure.
• Repairs and servicing must be performed by a qualified repair
facility
• DO NOT allow children to operate the laser tool.
• DO NOT operate the laser around children.
• DO NOT Remove warning labels from the tool.
Operating Tips
• Ensure batteries are in good working condition. If the “Power” LED
light is flashing, the batteries need replacement.
• To extend battery life, turn laser off when not working with or mark-
ing the beam.
• To ensure the accuracy of your work, check to make sure your
laser is calibrated often. See “Field Calibration” section of this
manual.
• Before attempting to level the laser, make sure the tool is posi-
tioned securely on a relatively smooth surface.
• The more accurately centered the bubbles are in the vials, the
more accurate the laser beam will be for working.