Filter
Top Products
6
English
Depress the spring loaded Manual Head Rotation Button (A) on the
top of the protective cap. The button will make contact with the rotary
laser head. While maintaining pressure on the Manual Head Rotation
Button, you can now turn the button and direct the laser beams in the
direction of your mark.
Since the laser has been designed with dual, side by side laser
diodes, you will see 2 laser dots on the object you are projecting the
beam onto. Marks can be made using either laser dot. Mark the cen-
ter of the dot.
DO NOT attempt to use the Manual Head Rotation Button while the
rotary head is spinning.
While using the Manual Head Rotation Button, it is recommended that
you set the Bump Sensor to Setting 1. See Bump Sensor operation.
NOTE: After storing this product in extremely cold conditions, the laser
head may not immediately rotate when turned on. The rotary head
may be started by depressing and turning the Manual Rotation Button
counterclockwise.
Laser Enhancement Glasses
The DEWALT Laser Kit includes a pair of Laser
Enhancement Glasses. These red lens glass-
es improve the visibility of the laser beam
under bright light conditions or over long dis-
tances. These glasses are not required to operate the laser but are
helpful. Working best indoors, the lens filters out ambient light and
intensifies the red laser dot or line to your eyes.
CAUTION: These glasses are not ANSI approved safety glasses
and should not be worn while operating other tools. These glasses do
not keep the laser beam from entering your eyes.
DANGER: NEVER STARE DIRECTLY INTO THE LASER BEAM,
WITH OR WITHOUT THESE GLASSES.
Target Card
The DEWALT Rotary Laser Kit includes a Laser Target Card to aid in
locating and marking the laser beam. The target card enhances the
visibility of the laser beam as the beam crosses over the card. The
card is marked with standard and metric scales.
The laser beam passes through the red plastic and
reflects off of the reflective tape on the reverse side.
The magnets at the top hold the target card to ceil-
ing track or steel studs to determine plumb and level
positions. When using the Target Card, for best per-
formance, the D
EWALT logo should be facing you.
Digital Laser Detector
The DEWALT Digital Laser Detector enables you to
locate a laser beam emitted by a Rotary Laser in
bright light conditions or over long distances. The
detector can be used in both indoor and outdoor situations where it is
difficult to see the laser beam. The detector is not for use with non-
rotating lasers.
The detector gives both visual and audio signals as to the location of
the laser beam as the beam crosses over the detector. The D
EWALT
Digital Laser Detector is compatible with most rotary lasers on the
market today. The clamp attaches the Digital Laser Detector to grade
rods, leveling poles, wall studs or posts. The detector can also be
mounted to ceiling track by attaching the magnets on the top of the
detector to the track.
POWER
ON
VOLUME
LEVEL
BATTERY
COMPARTMENT