Filter
Top Products
63
GATE ROTOR ROLLER BEARING REMOVAL
A) Refer to section REMOVAL ( All VSG) for removal
of the gate rotor bearing housings and gate rotor
supports.
B) Remove the snap ring (131), which retains the
roller bearing in the bearing housing.
C) Remove the roller bearing (125) from the bearing
housing (112).
D) Use a bearing puller to remove the roller bearing
race (125) from the gate rotor support (110).
GATE ROTOR ROLLER BEARING INSTALLATION
A) Match up the part numbers on the inner race to
the part numbers outer race. Press the bearing
race (numbers visible) onto the gate rotor sup-
port.
B) Install the outer bearing into the bearing housing
so the numbers match the numbers on the inner
race. Install the snap ring retainer in the housing.
The bevel on the snap ring must face away from
the roller bearing.
C) For installation of the bearing housing, refer to
section INSTALLATION (All VSG Models).
Service