Filter
Top Products
Replacement Procedure
1. Hold the carbon brush inside the brush body, and
insert the brush into the mounting slot (as shown
below)
Instruction Manual 27
.
into the slot.
. Replace the two brush mounting screws.
4. Replace the two wire connectors to the terminals
o t
2. Fully seat the brush
3
n he brushes.
into the router.
► under the copper
by the strap.
► place. If the
module does not press in freely, something must
► e top of the
mot h the top of the
cop
5. Press the electronics module back
Make sure the wires passing
strap are not pinched
Do not force the electronics into
be in the way.
When fully inserted, the tab on th
or housing will be flush wit
per strap.
led.
Note that during the break-in period while the
new brushes conform to the shape of the
armature contacts, the brushes may exhibit more
arching (sparking) than normal.
6. Carefully examine the wires. Make sure they are
routed properly and will not be pinched when the
covers are instal
7. Reinstall the covers on the router.