Filter
Top Products
Dust Collection
Instruction Manual 9
Dust Extraction Hood
The dust extraction
hood can be installed on
the top of the router
base and connected to a
vacuum for dust
collection.
To install the dust
extraction hood, insert
the mounting tabs into
the router base, and turn
the retaining latch to the
locked position.
Make sure the router bit
won't cut into the
extraction hood.
Chip Diverter
The chip diverter is used for edge forming to keep the
routing debris from coming back toward the operator.
This can be used with or without dust extraction. To
install the chip diverter:
1. Lay the router on its side.
2. Insert the tabs of the chip diverter into the accessory slots
and push in until you hear the locking tabs click.
3. Verify that the diverter is fully seated and latched. Note
the position of the locking tab in the upper left picture
when the diverter is not fully latched.