Fluke PM-3390B Sander User Manual


 
COMMAND REFERENCE 4 - 57
FORMat[:DATA]
Syntax:
FORMat[:DATA] INTeger[, 8 | 16]
INTeger,8 Trace point of 8 bits (one byte).
INTeger,16 Trace point of 16 bits (two bytes).
Query form:
FORMat[:DATA]?
Response:
INT,8 | INT,16
INT,8 Trace point consists of one byte.
INT,16 Trace point consists of two bytes.
Description:
Programs the number of bits of the trace data points. If the oscilloscope is in the
analog mode, error -221 "Settings conflict;Digital mode required" is generated.
After a
*
RST command, the number of bits is 16.
Example:
Send
FORMat INTeger,8 Programs the resolution at 8 bits.
Send
TRACe? M1_4 Queries for trace 4 in memory register 1.
Read
<trace_block> Each trace point consists of 8 bits.
Note: This only works when a trace was stored before in M1-4.