Filter
Top Products
Cleanup
12 332161A
11. Turn pressure control knob all the way down and
power switch OFF. Unplug sprayer.
12. Remove filter from gun if installed. Clean and
inspect. Install filter. See gun manual.
13. If flushing with water, flush again with mineral spirits
or Pump Armor to leave a protective coating to pre-
vent freezing or corrosion.
14. Wipe sprayer, hose and gun with a rag soaked in
water or mineral spirits.
15. Insert suction tube into cup to catch any drips.
Power Flush
™
Power flushing is a faster method of flushing. It can only
be used after spraying water-based coatings.
1. Perform Relieve Pressure Procedure, page 6.
2. Remove guard and spray tip. For additional informa-
tion, see gun manual.
3. Remove siphon tube set from paint. Wipe excess
paint off outside of tubes.
4. Unscrew inlet strainer from suction tube. Place inlet
screen in waste pail.
5. Screw shutoff valve onto garden hose. Turn lever
and open valve.
ti5316a
/.
/&&
ti20417a
ti4296a
ti2895a
ti2783a
ti20403a
This equipment stays pressurized until pressure is
manually relieved. To help prevent serious injury from
pressurized fluid, such as skin injection, splashing
fluid and moving parts, follow the Pressure Relief Pro-
cedure when you stop spraying and before cleaning,
checking, or servicing the equipment.
ti20408a
ti9433a
ti9412a