Graco 262906 Paint Sprayer User Manual


 
Startup
332161A 9
Startup
1. Turn pressure control to lowest pressure.
2. Turn power ON.
3. Increase pressure 1/4 turn to start motor. Allow fluid
to circulate through drain tube for 15 seconds.
4. Turn prime valve horizontal.Take spray gun trigger
safety OFF.
5. Hold gun against grounded metal flushing pail. Trig-
ger gun and flush 1 minute.
6. Inspect for leaks. Do not stop leaks with hand or a
rag! If leaks occur, perform Pressure Relief
Procedure, page 6. Tighten fittings.
7. Place siphon tube in paint pail.
8. Trigger gun again into flushing pail until paint
appears.
9.
Move gun to paint pail and trigger for 20 seconds. Set
gun safety ON.
10. Screw tip assembly onto gun. Tighten. For gun
assembly instructions, see gun manual.
ti20417a
ON
OFF
ti5303a
1/4 turn
ti20418a
ti20407a
TIAB
Flush
Do NOT place hands in front of tip.
TIA
PAINT
Flush
ti2599c
0!).4
ti5313b
ti20416a