Filter
Top Products
Setup
310692D 9
Setup
Flushing the gun
1. To flush the gun, use a solvent that is compatible
with paint to be sprayed. Hold a metal part of the
gun firmly to a grounded metal pail. Trigger the gun
to flush solvent through gun.
Connecting the air line
2. Install an air pressure regulator (F). See FIG. 1.
3. Install an air filter (G). See F
IG. 1.
4. Use a 5/16 inch (7.9 mm) I.D. air hose to minimize
excessive pressure drop in the hose.
5. Connect the air hose (D) to the 1/4 npsm gun air
inlet (C).
6. Connect the other end of the air hose (D) to a regu-
lated air supply line.
Flush the spray gun before putting any paint
through the gun.
WARNING
Read warnings, page 3. Follow Top and bottom feed
guns installation, page 8.
F
IG. 2
ti4836a
FIG. 3
F
IG. 4
ti4837a
C
D
ti4838a
D