Filter
Top Products
Clean Up
22 334558C
Clean Up
1. Perform Pressure Relief Procedure,
page 13, steps 1-7.
2. Remove Guard and SwitchTip.
3. Remove siphon tube set from paint and
place in flushing fluid. Use water for
water-based paint and mineral spirits for
oil based paint.
4. Turn engine ON and start engine or plug
motor in and turn ON. Turn hydraulic
pump valve ON. Turn prime valve to
SPRAY position.
5. Hold gun against pail. Disengage trigger
lock. Turn pressure control up until motor
begins to drive pump. Trigger gun until
flushing fluid appears.
6. Move gun to waste pail, hold gun against
pail, trigger gun to thoroughly flush
system. Release trigger and engage
trigger lock.
7. While continuing to trigger gun, turn
prime valve down. Then release gun
trigger. Allow flushing fluid to circulate
until fluid comes out of drain tube clear.
ti8687a
PAINT
WLD
PAINT
FLUSH
WLD
FLUSH
WLD
WLE
ti5271b
21
WLD