Graco 334558C Paint Sprayer User Manual


 
Troubleshooting
334558C 25
Troubleshooting
Problem Cause Solution
Gas engine pulls hard (won’t
start)
Hydraulic pressure is too high Turn hydraulic pressure knob
counterclockwise to lowest
setting
Gas engine does not start Switch OFF, low oil, no gasoline Consult engine manual
Fuel shut off valve closed Open fuel shut off valve
Gas engine does not work
properly
Faulty engine Consult engine manual
Elevation Refer to Engine Repair Kit, 4.0
hp - 288678 / 5.5 hp - 248943 /
6/5 hp - 248944 / 9.0 hp -
248945
Gas engine operates, but
displacement pump does not
operate
Hydraulic pump valve is OFF Set hydraulic pump valve ON
Pressure setting too low Increase pressure, page 18
Displacement pump outlet filter
(if used) is dirty or clogged
Clean the filter
Tip or tip filter (if used) is
clogged
Remove tip and/or filter and
clean
Hydraulic fluid too low Shut off sprayer. Add fluid*. See
page 16
Belt worn or broken or off Replace.
Hydraulic pump worn or
damaged
Bring sprayer to Graco
distributor for repair
Dried paint seized paint pump
rod
Service pump. See manual
334654
Hydraulic motor not shifting Set pump valve OFF. Turn
pressure down. Turn engine
OFF. Pry rod up or down until
hydraulic motor shifts.
Displacement pump operates,
but output is low on upstroke
Piston ball check not seating
properly
Service piston ball check. See
manual 334654
Piston packings worn or
damaged
Replace packings. See manual
334654