Filter
Top Products
Clean Up
334558C 23
8. Raise siphon tube above flushing fluid
and run sprayer for 15 to 30 seconds to
drain fluid. Turn hydraulic valve OFF.
Turn engine OFF or turn electric motor
OFF and unplug.
9. Engage trigger lock. Remove filters from
gun and sprayer, if installed. Clean and
inspect. Reinstall filters.
10. Depending on model, either remove nut
and inlet strainer screen from bottom of
suction tube, or unscrew and remove
inlet strainer. Clean and replace strainer
screen if necessary. Reassemble.
11. If flushing with water, flush again with
mineral spirits, or Pump Armor, to leave
a protective coating to prevent freezing
or corrosion.
12. Wipe sprayer, hose and gun with a rag
soaked in water or mineral spirits.
PAINT
FLUSH
WLE
ti8692a
ti15018a
ti8840a
ti9127a
ti2776a