Filter
Top Products
Repair
PowerPower
Power
SupplySupply
Supply
RemovalRemoval
Removal
andand
and
ReplacementReplacement
Replacement
• Inspect the gun handle power supply cavity for dirt
or moisture. Clean with a clean, dry rag.
• Do not expose gasket (28) to solvents.
1. See Prepare the Gun for Service, page 37.
2. See Barrel Removal, page 42.
NOTICENOTICE
NOTICE
Be careful when handling the power supply
(11) to avoid damaging it.
3. Grasp the power supply (11) with your hand.
With a gentle side to side motion, free the power
supply/alternator assembly from the gun handle
(16), then carefully pull it straight out.
OnSmart
Modelsonly,
disconnect the exible circuit (24)
from the socket at the top of the handle.
4. Inspect the power supply and alternator for
damage.
5. To separate the power supply (11) from the
alternator (15), disconnect the 3-wire ribbon
connector (PC) from the power supply.
OnSmart
Modelsonly,
disconnect the 6–pin exible circuit
(24) from the power supply. Slide the alternator
up and off the power supply.
6. See Test Power Supply Resistance, page 32.
Replace the power supply if necessary.
To repair the alternator, see
Alternator Removal and Replacement, page 44.
To prevent damage to the cable and possible
interruption of the ground continuity, bend the
alternator’s 3–wire ribbon cable (PC) upward
and back, so the bend faces the power supply
and the connector is at the top.
7.
Smartmodelsonly:
connect the 6–pin exible
circuit (24) to the power supply.
8. Connect the 3-wire ribbon connector (PC) to the
power supply. Tuck the ribbon forward, under
the power supply. Slide the alternator (15) down
onto the power supply (11).
9. Insert the power supply/alternator assembly in
the gun handle (16). Make sure the ground strips
(EE) make contact with the handle. On Smart
models, align the connector of the 6–pin exible
circuit (24) with the socket (CS) at the top of the
handle. Push the connector securely into the
socket as you slide the power supply/alternator
assembly into the handle.
Figure 26 Connect Flexible Circuit
10. Make sure the gasket (28*), ground spring (18),
and power supply spring (11a) are in place.
Assemble the barrel (1) to the handle (16). See
Barrel Installation, page 42.
11. See Test Gun Resistance, page 31.
Figure 27 Power Supply
3A2494D43