Filter
Top Products
6
307-730
SETUP
SUCTION
HOSE
PRIMING TUBE
INLET V
ALVE
MOTOR
ON/OFF SWITCH
POWER SUPPL
Y CORD
ROLLER V
ALVE
PRIMING V
ALVE
P
AINT FIL
TER
25 FT
. (7.6 M) HOSE
18 INCH EXTENSION
9 INCH ROLLER FRAME
ROLLER COVER
0285
USE TWO WRENCHES
T
O TIGHTEN
SPRING GUARD MUST BE
A
T ROLLER V
AL
VE INLET
TRIGGER
HAND TIGHTEN ONL
Y
TO AVOID CRACKING
ROLLER COVER
USE TWO WRENCHES
T
O TIGHTEN
BE SURE GASKETS ARE
INST
ALLED A
T THESE JOINTS
USE TWO WRENCHES
T
O TIGHTEN
Fig
1
1. Remove
all parts from the boxes and assemble them
as
shown in Fig
1, following the notes on the drawing.
2. Prepare the paint according to the manufacturer ’s
recommendations.
Remove any skin
that may have
formed on the top of the paint. If necessary
, thin the
paint.
Never
remove
the third (grounding) pin of the power
supply
cord. Be sure the outlet
is properly grounded.
In
the event of an electrical short circuit, grounding
reduces
the risk of an electric shock by providing an
escape
wire for the electric current.
Inspect the power supply cord and extension cord
before
each use. Be sure they are in good condition
and
have
undamaged three-pin plugs. Replace im
-
mediately if either cord shows signs of wear or
damage.
WARNING
3. Plug
the power supply cord into a properly grounded,
120 V electrical outlet. See Fig 2. Do not use an
adapter. All extension cords must have three wires.
Use the chart below for selecting the appropriate
wire
gauge for the extension cord.
Cord Length Extension
feet (meters) W
ire Gauge
1–100 (1–30) 18
100–200 (30–61) 16
200–300 (61–92) 14
over 300
(over 92) 12
Fig 2
0286
GROUNDED
OUTLET
GROUNDING
PIN