Filter
Top Products
Model G0440/G0441 (Mfg. Since 03/12)
-19-
Assembly
To assemble dust collector:
1. With the help of assistants or power lifting
equipment, secure the motor/blower housing
assembly onto the hardware you mounted in
the Wall Mounting section.
2. Attach the 3 x 6mm foam tape to the top of
the intake cylinder, as shown in Figure 10.
Figure 10. Foam tape stuck on intake cylinder.
Intake
Cylinder
Foam Tape
3. Attach the intake cylinder to the bottom of the
housing, as shown in Figure 11, using (4)
5
⁄16"-18 x
3
⁄4" hex bolts and (4)
5
⁄16" flat wash-
ers.
Note: Because this part of the dust collector
will not be accessible after assembly, con-
sider using medium strength thread locking
compound on the bolts that secure the intake
cylinder to the motor/blower housing assem-
bly. This added measure will ensure that the
fasteners will not come loose from vibration.
4. Temporarily attach the intake barrel to the
housing with a barrel gasket in between, as
shown in Figure 12, using (4)
5
⁄16"-18 x
3
⁄4"
hex bolts and (4)
5
⁄16" flat washers—and only
snug the bolts, rather than fully tighten them.
Figure 12. Securing blower on intake barrel.
Gasket Here
Intake Barrel
Figure 11. Attaching intake cylinder to the
bottom of motor housing.
Intake
Cylinder
Motor
Housing
HEAVY LIFT!
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a fork lift (or other
lifting equipment) rated for
weight of this machine.