Filter
Top Products
Model G0440/G0441 (Mfg. Since 03/12)
-25-
22. Fit the plastic canister collection bag over
the bottom of the canister filter and clamp in
place with the metal bag clamp, as shown in
Figure 32.
Figure 32. Plastic collection bag clamped in
place under filter.
Bag
Clamp
23. Mount the switch on the funnel, as shown in
Figure 33, with the (2)
5
⁄16"-18 x 1" hex bolts,
(4)
5
⁄16" flat washers, and (2)
5
⁄16"-18 hex nuts.
Te s t R u n
Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 41.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Press the ON/OFF button to turn the machine
ON.
4. Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— Strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
5. Press the TIMER button and cycle through
each of the times to make sure the lights illu-
minate on the switch.
6. Press the TIMER on the remote control and
cycle through each of the times in the same
manner as Step 5.
7. Press the ON/OFF button on the remote con-
trol to make sure it is working properly.
Figure 33. Switch mounted to funnel.