Filter
Top Products
G0484 Gear Head Mill/Drill
-11-
Inventory
After all the parts have been removed from the
crate, you should have the following items with
your machine:
Inventory: (Figure
3) Qty
A. Downfeed Handles ..................................... 3
B. Face Mill Assembly R8 ............................... 1
C. Adapter R8 - JT3 ........................................ 1
D. Headstock Elevation Crank ........................ 1
E. Wrench 24mm ............................................ 1
F. Hex Wrenches, 4, 5, 6 mm ...................1 Ea
G. Handwheels ................................................ 2
H. Chuck 1–16mm JT3 ................................... 1
I. Chuck Key .................................................. 1
J. Handwheel Handles ................................... 2
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed. Check mount
-
ing locations before assuming that any
items from the inventory list are missing.
Inventory
A
B
C
D
E
F
G
H
I
Figure 3. Model G0484 inventory.
J
The unpainted surfaces are coated with a waxy
oil to prevent corrosion during shipment. Remove
this protective coating with a solvent cleaner or
citrus-based degreaser such as Grizzly’s G7895
Citrus Degreaser. To clean thoroughly, some parts
must be removed. For optimum performance
from your machine, clean all moving parts or
sliding contact surfaces. Avoid chlorine-based
solvents, such as acetone or brake parts cleaner
that may damage painted surfaces. Always follow
the manufacturer’s instructions when using any
type of cleaning product.
Clean Up
Figure 4. Grizzly citrus degreaser.
G7895—Grizzly Citrus Degreaser
This natural, citrus-based degreaser is a great
solution for removing export grease, and it’s much
safer to work around than nasty solvents.
Gasoline and petroleum
products have low flash
points and can explode or
cause fire if used to clean
machinery. DO NOT use
these products to clean
the machinery.
Many cleaning solvents are
toxic if inhaled. Minimize
your risk by only using
these products in a well
ventilated area.
Clean Up