Filter
Top Products
G0512 Edge Sander -21-
Edge & End Sanding
To perform an edge or end sanding operation:
1. Make sure the vertical tracking on the sand-
ing belt is set.
2. Start the sander by pulling the switch up.
3. Support the workpiece against the back stop,
keep your fingers away from the moving belt
and slowly feed the workpiece into the mov-
ing belt, as shown in Figures 23 & 24.
Figure 23. Typical edge sanding operation.
Figure 24. Typical end sanding operation.
Keep loose clothing out
of the way of machinery
and keep hair pulled
back during operations!
If you must feed a workpiece into the sand-
ing belt corner first, feed the trailing corner
first. Feeding the leading corner first, could
cause the sanding belt to grab the work-
piece and jerk it out of your hands.