Filter
Top Products
G0512 Edge Sander -23-
Disconnect power to the
machine when perform-
ing any adjustments or
maintenance. Failure to
do this may result in seri-
ous personal injury.
Regular periodic maintenance on your Grizzly
Edge Sander will ensure its optimum perfor-
mance. Make a habit of inspecting your sander
each time you use it. Check for the following con-
ditions and repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Any other condition that could hamper the
safe operation of this machine.
Bearings
Since all bearings are shielded and permanently
lubricated, simply leave them alone until they
need to be replaced. DO NOT lubricate them.
Table Height Lead Screw
Wipe off built-up sawdust and lubricate with an
occasional shot of white lithium grease. After
lubricating, be sure to move the lead screw
through the full range of motion that it can travel,
so that the grease is spread evenly.
The sanding belt should be regularly cleaned as
it becomes clogged with sawdust. Clean the
sanding belt with PRO STIK
®
belt cleaners
(Model G1511/G1512). Belts that are regularly
cleaned have a much longer useful life, than belts
that are neglected. See page 31 for more detail
on PRO STIK
™
belt cleaners.
The laminate surface on the table can be wiped
clean with a dry towel or cleaned with a solvent
designed to remove wood resins if the table is
gummy.
DO NOT expose the underside of the table to
water because it may warp.
Sanding Belt
Lubrication
Table
General
SECTION 7: MAINTENANCE