Filter
Top Products
-12-
G0547 Combo Sander
Loose hair and clothing
could get caught in
machinery and cause
serious personal injury.
Keep loose clothing
rolled up and long hair
tied up and away from
machinery.
Serious personal injury
could occur if you con-
nect your machine to the
power source before you
have completed the
assembly process. DO
NOT connect the
machine to the power
source until instructed to
do so.
!
Sharp edges on metal
parts may cause person-
al injury. Examine the
edges of all metal parts
before handling.
This section will cover the basic assembly and
adjustment instructions needed to begin opera-
tion. Complete the assembly in the order provid-
ed in this manual and then read the remaining
portion of the manual before attempting any type
of operation.
Your safety is important! Please follow the
warnings below during this entire section:
To mount the sander to a workbench:
1. Screw
1
⁄4" x 1
1
⁄2" (or longer) lag bolts with
1
⁄4"
washers through the holes in the base and
into the workbench.
To attach the sander to a mounting board:
1. Mount the base of the sander to the center of
a piece of
3
⁄4" plywood that is at least 18"W x
24"D.
2. Clamp the plywood securely to a workbench.
To install the disc guard:
1. Align the disc guard with the holes on the
lower half of the disc.
2. Use the M4 x 8 self tapping screws to attach
the disc guard to the sander base as shown
in Figure 4.
Figure 4. Attaching the disc guard.
Installing Disc
Guard
Mounting SanderBeginning Assembly