Filter
Top Products
-20-
G0547 Combo Sander
Miters can also be sanded by changing the angle
of the table.
To perform angle sanding operations:
1. Loosen the knob securing the table.
2. Use the angle gauge to acheive the desired
table angle and tighten the handles. Note—
The disc table can be positioned from 0˚ to
45˚, relative to the plane of the sanding sur-
face.
3. Slide the miter gauge into the miter slot and
use the miter gauge to hold your workpiece
in position.
4. With light, but firm pressure, push the work-
piece slowly into the downspin side of the
rotating disc (Figure 19).
Figure 19. Mitering with the table angled.
The disc sanding table can be removed and
installed on the sanding belt bed when the sand-
ing belt bed is vertical. This gives the operator
more working room when using the sanding belt.
To install the table on the sanding belt bed:
1. Disconnect the machine from the power
source!
2. Raise the belt bed to vertical and remove the
back stop.
3. Remove the disc sanding table.
4. Place the index pin of the disc sanding table
in the upper hole in the sanding belt table.
5. Rotate the sanding table perpendicular to the
sanding belt and screw in the knob as shown
in Figure 20.
Figure 20. Installing the table for belt sanding.
Installing Table on
Sanding Belt
Angle Sanding
5. Move the workpiece slowly back and forth
across the downspin side of the disc.
Always keep the workpiece on the side of
the wheel that is rotating down toward the
table. This will keep the workpiece from
flying out of your hands from the rota-
tional forces.
!