Filter
Top Products
G0547 Combo Sander -13-
To install the disc table:
1. Lay the table upside down and align the table
support with the holes in the table.
2. Take three hex bolts out of the hardware bag
and put a lock washer and a flat washer on
each bolt.
3. Screw the hex bolts with washers through
the table support and into the disc table as
shown in Figure 5.
Figure 5. Bolting the table support to the disc table.
Figure 6. Inserting the index pin into the base.
4. Insert the index pin shown in Figure 6 into
the upper hole on the base and tighten the
knob.
Squaring Table
When the table tilt is set to 0˚, the table should be
adjusted perpendicular to the sanding disc face.
To square the table:
1. Disconnect the machine from the power
source!
2. Using a try square or machinist’s square, set
one edge on the table surface and the other
against the face of the disc as shown in
Figure 7.
Figure 7. Squaring disc table.
Installing Disc Table
!
3. Loosen the lock knob and adjust the table
angle until there is no gap between the disc
face and the square.
4. Tighten the lock knob while holding the table
perpendicular.
5. Place the angle measurement label on the
base so the angle indicator points to 0˚.
Index Pin