Filter
Top Products
Figure 12. Squaring the back stop
Figure 11. Raising the sanding belt bed.
!
-16-
3. Slide the belt onto the drive drums as shown
in Figure 13 and release the belt tensioning
lever.
Note—make sure that the arrow on the inside of
the sanding belt points the same direction as the
belt rotation arrow on the machine.
G0547 Combo Sander
To adjust the sanding belt angle:
1. Disconnect the machine from the power
source!
2. Loosen the cap screw shown in Figure 11.
To install the back stop:
1. Screw a hex bolt, with a flat washer and a
lock washer on it, through the back stop and
into the hole shown in Figure 12.
2. Square the back stop as shown in Figure 12
and tighten the hex bolt.
3. Raise the sanding belt to the desired angle
and tighten the cap screw.
Figure 13. Installing belt.
To install the sanding belt:
1. Disconnect the machine from the power
source!
2. Loosen the belt tension by pulling out the
tensioning lever shown in Figure 13.
!
Belt
Tensioning
Lever
Installing Sanding
Belt
Installing Back Stop
Adjusting Belt Angle