Filter
Top Products
-4-
Model G0746/G0749 (Mfg. Since 3/13)
Identification
A. Headstock
B. D1-8 Camlock MT#7 Spindle
C. 3-Jaw Chuck 10"
D. Steady Rest
E. Halogen Work Lamp
F. Follow Rest
G. 4-Way Tool Post
H. Compound Rest
I. Coolant Nozzle & Valve
J. Tailstock (see Page 6 for details)
K. Longitudinal Leadscrew
L. Feed Rod
M. Control Rod
N. Coolant Reservoir & Pump Access
O. Chip Drawer
P. Safety Foot Brake
Q. Carriage (see Page 6 for details)
R. Micrometer Stop
S. Leadscrew Feed Rod Selection Lever
T. Quick-Change Gearbox Controls (see Page
5 for details)
U. Headstock Controls (see Page 5 for details)
Serious personal injury could occur if
you connect the machine to power before
completing the setup process. DO NOT
connect power until instructed to do so later
in this manual.
Untrained users have an increased risk
of seriously injuring themselves with this
machine. Do not operate this machine until
you have understood this entire manual and
received proper training.
Figure 1. Model G0746 identification.
B
D
C
J
A
S
Q
R
E
F
G
H
I
K
L
N
OP
T
M
U