Filter
Top Products
Model G0765 (Mfd. Since 5/15)
-49-
Lubrication
NOTICE
The recommended lubrication is based on
light-to-medium usage. Keeping in mind
that lubrication helps to protect the value
and operation of the lathe, these lubrication
tasks may need to be performed more fre-
quently than recommended here, depend-
ing on usage.
Failure to follow reasonable lubrication
practices as instructed in this manual could
lead to premature failure of lathe compo-
nents and will void the warranty.
Lubrication Task Frequency
Page
Ref.
Ball Oilers Daily
This
Page
Leadscrew & Carriage
Rack
Daily
52
Bedways Daily
52
Cross Slide & Compound
Slide
Daily
52
Change Gear Bushing Annually
53
Tumbler Gears Annually
53
Lubrication Frequency
Items Needed Qty
Clean Rag ........................................ As Needed
Mineral Spirits .................................... As Needed
Stiff Brush .......................................................... 1
Wrench 4mm ..................................................... 1
Pump-Type Oil Can w/Plastic Cone Tip ............ 1
Ball Oilers
Oil Type ..............................ISO 32 or Equivalent
Amount .....................................1 or 2 Squirts/Fill
Lubrication Frequency ................................. Daily
This lathe has four ball oilers that should be oiled
on a daily basis before beginning operation.
Proper lubrication of ball oilers is done with a
pump-type oil can that has a plastic or rubber-
ized cone tip. We do not recommend using metal
needle or lance tips, as they can push the ball too
far into the oiler, break the spring seat, and lodge
the ball in the oil galley.
Lubricate the ball oilers before and after machine
use, and more frequently under heavy use. When
lubricating ball oilers, first clean the outside sur-
face to remove any dust or grime. Push the tip of
the oil can nozzle against the ball oiler to create
a hydraulic seal, then pump the oil can once or
twice. If you see sludge and contaminants coming
out of the lubrication area, keep pumping the oil
can until the oil runs clear. When finished, wipe
away any excess oil.
Refer to Figure 75 to identify the location of each
ball oiler.
Figure 75. Ball oilers.
Ball Oilers
The lathe has metal-to-metal sliding surfaces that
require regular lubrication to maintain smooth
movement and ensure long-lasting operation.
Other than the lubrication points covered in this
section, all other bearings are internally lubricated
and sealed at the factory. Simply leave them
alone unless they need to be replaced.
Before performing any lubrication task,
DISCONNECT LATHE FROM POWER!
We recommend using Model SB1365 Way Oil or
equivalent (see Page 49) for most of the lubrica-
tion tasks.