Filter
Top Products
-14-
Model G0766 (Mfd. Since 07/15)
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
After all the parts have been removed from the
shipping containers, you should have the follow-
ing items:
Inventory: (Figures 5–7) Qty
A. Lathe Assembly
—Headstock (mounted) ............................. 1
—Tool Rest Base (mounted) ...................... 1
—Tailstock (mounted) ................................. 1
—Faceplate 6" (installed) ........................... 1
B. Stand Legs ................................................. 2
C. Live Center MT#2 ....................................... 1
D. Spur Center MT#2 ...................................... 1
E. Indexing Pin ................................................ 1
F. Tool Rest .................................................... 1
G. Hex Wrenches 3, 4, 6, 8mm ..................1 Ea
H. Machine Feet .............................................. 4
I. Knockout Tool ............................................. 1
J. Hardware (not shown)
—Cap Screws M8-1.25 x 35 .................... 10
—Lock Washers 8mm .............................. 10
—Hex Nuts M8-1.25 ................................... 2
Figure 5. Lathe assembly.
A
Figure 6. Stand legs.
B
Figure 7. Loose inventory components.
C
D
E
F
H
I
G